System Components

 Quick Install: MxThinClient Configurator

IP video interface for live image display of cameras and door stations on a monitor/TV

MOBOTIX offers a particularly simple and compact solution for displaying the live image of a MOBOTIX camera (from model series x24, x14 and later) on a monitor or TV with HDMI connection. To do so, the MxThinClient is simply connected via a network cable to a free PoE port of the switch where the displaying camera is connected as well.


  • Live display of one or several MOBOTIX cameras or images of a connected web server on a monitor/TV, either permanently or in a controlled looping sequence
  • Display of the camera with the most recent event, for example a motion detection
  • License- and maintenance-free with a power consumption of only 2 Watts
  • “Boot-Stable“ with reliable autostart after power failure. Display of the missing camera connection on screen.

Article number:

More information
 Quick Install: MxSwitch Configurator
  • Easy to install on TS35 DIN rails, width: 6HP (108 mm)
  • Four PoE+ powered network ports RJ45 (max. 25,5 W per port, max. 75 W total load on all four PoE+ ports combined)
  • One RJ45 network port for connecting to switch, router or computer (uplink)
  • Built-in 12 V DC/1 A power supply for door opener (e.g., switched on/off by BellRFID or KeypadRFID)
  • Unused wire pairs 4/5 and 7/8 on network installation cable for PoE ports A/D available directly on screw terminals (MxSplit)
  • Pushbutton inside applies 12 V DC for 90 seconds to terminals 17/18 (for purposes of temporarily overriding anti-theft lock in frame of Door Stations and MxDisplay+ units)
  • Future expansion option for DIN rail modules already integrated (backbone)

Required Accessory (not included): External power supply device 48 V DC (output current min. 2 A)

Article number:

More information
  • Four sensors in a single device: PIR, temperature, noise, illumination
  • Low power consumption of typically only 0.1 W
  • Enhanced security by covering areas where no camera is installed
  • Available as cost-efficient indoor or putdoor variants
  • Use of the many mounting accessories for sensor modules for simple ceiling or wall mounting

Article numbers:
MX-MULTISENSE1 (Indoor variant)
MX-MULTISENSE1-EXT (Outdoor variant)

More information
  • Extension for MOBOTIX cameras
  • Microphone/speaker
  • PIR sensor for motion detection, temperature sensor
  • Integrated switch functions
  • not for Basic models

Article number:

More information
  • Practical, optional extension board only for Indoor Cameras p25, i25, v25 and c25
  • Expands every camera to include two extra inputs and two 12V outputs
  • Enables access to the two-wire MxBus
  • Outputs can be directly connected to a relay and thus higher voltages and loads

Article number:

More information
MX IO2 Module Ethernet connection

The Ethernet terminal board is used for the secure connection of the camera module via an RJ45 plug with the 8 wires of the network cable.

(Only for door stations without Mx2wire)

Article number:

More information
 T25 Hemispheric IP Video Door Station T25 Quick Guide T25 Drilling Templates T25 Quick Installation T24MX Part 1 T24MX Part 2 Configurator
MX IO Module

The extended terminal board provides an additional 8 inputs and 3 outputs to connect external devices.

Article number:

More information